Ok I'm starting to get frustrated trying to configure my remote access. The wizard will not work I skipped that part and set up my domain using the domain I had set up on v1. I went into my router and in order to set the ports up I need an application name and then starting port then an ending port I did 80 and 443 put in my ip address and saved the config after saying it is saved page pops back up and only my previous ports are listed and enabled. (ComicRack server) I'm not sure what to put as the app name and does that matter or is it just there for me to recognize what I have opened and doesn't really play a part in the functionality. I have a linksys wgrt router and access point set up as a repeater to extend my signal throughout the whole house could this also be the cause of the problem
↧