My PC did have the connector installed okay for a long time, then it suddenly stopped backing up.
So I uninstalled and tried to re-install the connector. The connector software runs and gets to the stage 'Connecting this computer to the network' where it hangs there for ~10 minutes and then gives a failure error.
I have tried renaming my PC and installing the connector again, but it fails at the same point. if I re-install it again, it says that the new PC name has been detected on the server (so it must have partially worked the first time?), but then it fails again at the same point.
My PC can access the drives on the WHS11, see all content, etc.
I have also tried installing the connector software onto a laptop that has not had it installed on before, but that failed at the same point.
Any ideas how to resolve this?
So I uninstalled and tried to re-install the connector. The connector software runs and gets to the stage 'Connecting this computer to the network' where it hangs there for ~10 minutes and then gives a failure error.
I have tried renaming my PC and installing the connector again, but it fails at the same point. if I re-install it again, it says that the new PC name has been detected on the server (so it must have partially worked the first time?), but then it fails again at the same point.
My PC can access the drives on the WHS11, see all content, etc.
I have also tried installing the connector software onto a laptop that has not had it installed on before, but that failed at the same point.
Any ideas how to resolve this?