I have been running Whs 2011 with LO for years with no major issues. A week ago I had a corrupted Client Backup Hardrive. When I tried to restore it from backup most of the restore failed. I did a backup repair task and all 4 pc's lost their backups. Additionally 3 of the 4 backups had to be reconfigured for the WHS backup and turned on.
The backups have worked well since then, but LO has had issues with what it is to do after the backup. The three pc's that had to have their backups reconfigured had to have their shutdown and reboot properties after backup turned on again. This was done but the properties keep reverting to do nothing. Additionally, when I scan the network for additional devices no scan seems to run and none of my other devices show up on the computers tab.
I am hoping to get some assistance with getting LO to work again at shutting down two of the pc's and rebooting the third after the whs backup. It just won't seem to keep the properties for the pc's for any length of time and even when the properties are correct, the pc's do not execute the commands.
I have removed LO from the clients and had them reinstalled. I have also removed the add-in from the server and then reinstalled it. I have also uninstalled the WHS Connectors and reinstalled them. Unfortunately those have not resolved the issue.
The backups have worked well since then, but LO has had issues with what it is to do after the backup. The three pc's that had to have their backups reconfigured had to have their shutdown and reboot properties after backup turned on again. This was done but the properties keep reverting to do nothing. Additionally, when I scan the network for additional devices no scan seems to run and none of my other devices show up on the computers tab.
I am hoping to get some assistance with getting LO to work again at shutting down two of the pc's and rebooting the third after the whs backup. It just won't seem to keep the properties for the pc's for any length of time and even when the properties are correct, the pc's do not execute the commands.
I have removed LO from the clients and had them reinstalled. I have also removed the add-in from the server and then reinstalled it. I have also uninstalled the WHS Connectors and reinstalled them. Unfortunately those have not resolved the issue.